1、濟南鋁板http://www.pdadn.com/中的鑄軋板是用鋁錠等原料熔煉后，鋁水直接流入兩個大滾輪之間，一次軋出想要的鋁坯，后經冷軋成型你想要厚度的鋁板，所以容易出現水波紋。
Jinan in casting aluminum plate is melting aluminum ingots and other raw materials, the aluminum water flows directly between two large rollers, rolling out a desired aluminum billet, after cold-molded aluminum thickness you want, so

easy water ripples.

2、濟南鋁板中的熱軋板就是鋁錠等原料熔煉后，鋁水流入一個方型的模中做出鋁坯，一般做出來的鋁坯比較厚，二三百或三四百毫米厚，鋁坯出來后還要經過五六百度的烘箱里面加溫幾個小時，后還要刨面，經熱軋后再冷軋等等工序，復雜好多，所以生產出來的鋁板比鑄軋達穩定多了，也好多了。
Jinan, the hot-rolled sheet aluminum ingots and other raw materials is, after smelting, aluminum water flows into a mold to make a square of aluminum billet, usually made out of aluminum billet is thick, two hundred, or three or four hundred millimeters thick, aluminum billet Came out to go through five or six Baidu inside heated oven for several hours, even after planing surface, hot rolled and then cold rolling process, and so, a lot of complexity, so produced stable than aluminum casting up, and much better.

3、濟南鋁板http://www.pdadn.com/不管熱軋板還是鑄軋板的最后都要經過冷軋定型，水波紋被最后軋板的兩個大軋輪給磨光了，未處理前肉前是看不見的，不過你可以在陽極前用堿洗或酸洗一下，這時應該也能看到一點了，接著如果用本色氧化就變明顯，硬質氧化則更明顯。
Regardless of Jinan rolled sheet or aluminum should last through the cold-rolled sheet casting stereotypes, water ripples are two large rolling wheels rolled plate to finish last, the former front unprocessed meat is invisible, but you can anode with caustic or acid before it, then it should also be able to see a little, then if the true nature of the oxidation becomes obvious, hard anodized even more obvious.