濟南鋁板http://www.pdadn.com/變形縫擋水板必須在混凝土澆筑之前就預埋在結構中，進入混凝土的寬度要大于80mm，上下分別伸出混凝土大約100mm，變形縫擋水板的式樣可以根據變形縫的性質進行調整。
Jinan Deformation aluminum flap must be done before the concrete pouring on embedded in the structure, into the concrete is greater than the width of 80mm, respectively, extending down concrete about 100mm, Shape Deformation flap can be adjusted according to the nature of the deformation joint .

濟南鋁板http://www.pdadn.com/預埋時要作固定，先在模板上準確畫出鋁板的位置線，然后根據畫好的位置線把一根直徑不小于16的鋼筋豎直的焊制在已經綁扎好的梁鋼筋上，再把鋁板用鐵絲固定在鋼筋上，如果梁突出墻面，鋁板就要置于梁鋼筋的骨架中，這時梁端鋁板位置的箍筋不要綁扎，縫兩側的模板在安裝時，模板需要在鋁板的位置斷開，加固的時候貼近鋁板插入一根鋼管再用木楔擠牢，在澆筑混凝土的時候，此處要分層澆筑。
Jinan when embedded aluminum to make fixed, first on the template to draw the exact location of the line of aluminum, and then draw a good position line to a diameter of no less than 16 of the vertical steel welded in steel beams have been on a good lashing , then aluminum fixed on steel, if the beam protruding walls, aluminum and steel beams should be placed in the skeleton, then the aluminum stirrup beam end position not binding with wire, both sides of the seam during the installation template, template need to close off position aluminum in aluminum, steel reinforcement when inserting a wedge and then squeeze firmly in pouring concrete when pouring here to be layered.