濟南花紋鋁板在生活中作用是很大的，由于在生產過程中經常會出現鑄錠疏松或是氣孔等缺陷，給生產過程帶來很多麻煩，要想濟南花紋鋁板更漂亮，需要對其進行水洗處理，下面濟南廣大鋁業的有關專家就給大家介紹一下花紋鋁板是如何清洗的？
1、經堿蝕后花紋鋁板表面會殘留大連的堿蝕槽液膜，濟南鋁板的有關技術人員說這時我們要從有利于清洗產品的角度出發,第一個水槽的水要保持溫度和堿性，就不要去更換水，為了使清洗效果更好,我們可以適當的其攪拌。
After alkaline etching pattern aluminum surface will be left Dalian alkaline etching grooves film, the technical staff Jinan aluminum say when we want conducive cleaning product point of view, the first tank of water to keep the temperature and alkalinity, is not going to replace the water, in order to clean better, we can appropriate their agitation.
2、濟南鋁板的有關技術人員建議使用循環流動水清洗，這樣做的目的是為了保護氧化槽的正常時用，因為在中和槽內有硝酸,它如果被帶入到氧化槽中的話,就有可能形成不了氧化膜,或者在氧化槽中的雜質的增加,這樣會加快氧化槽的老化。
Jinan technical staff recommended to use an aluminum plate cleaning circulation water, which purpose is to protect the normal time by the oxidation tank, neutralization tank as nitric acid, it was brought to the oxidation tank, if so, it is possible can not form an oxide film, or increasing the oxidation tank impurities, this will accelerate the aging of the oxidation tank.
3、化學拋光后的水洗，化學拋光后會從殘留一些藥液,濟南鋁板的有關技術人員建議第二水槽使用循環流動水洗,第一個水槽保持溫度就行了。
After washing chemical polishing, chemical polishing will post some residual liquid from Jinan aluminum of the technical staff recommends the use of a second circulating water tank, the first tank to keep the temperature on the line.

4、濟南花紋鋁板在除油后后會殘留一些藥物和油垢，要將其清洗干凈，以免在后續清洗中因攜帶油垢而產生不良品。
Jinan pattern aluminum in the oil after some residual drugs and grease, you want to clean, in order to avoid subsequent cleaning grease for carrying produce defective products.

濟南鋁板：http://www.pdadn.com/